PRIMEX

PRIMEX – EPDM is a low-viscosity solution of synthetic rubber and resins combined with organic, halogen-free solvents. It is intended for use for the lap joint. Primex has been formulated with VOC-exempt solvents for use in regulated markets where other solvent-borne primers can not be used. This primer does not react with atmospheric moisture allowing it to be opened and resealed for use at a later date.

PRIMEX is suitable for sealing the laps. All surfaces to be primed must be firm, flat, dry, and free from dust and grease. PRIMEX is applied to the substrate with a brush or lambs wool roller. Laps should be at least 50mm and spread PRIMEX across the lap area. All work surfaces should be clean, dry, and free of dirt, dust, debris, oils, unadhered coatings, deteriorated membranes,s and other contaminants that may result in a surface that is not sound or is uneven. If necessary, clean the surface with an approved EPDM or TPO membrane cleaner before application.

Primex is a combustible material and should be shipped and stored away from open flames, heat or sources of ignition. Keep all pails tightly sealed while in storage. It should be used only in well-ventilated areas. It may cause eye, skin and respiratory irritation, and is harmful or fatal if swallowed. Avoid contact with skin. Use impervious clothing and rubber gloves to avoid prolonged or repeated contact with skin. Read the container label and follow all safety instructions.