EPOXY BONDING AGENT AND ADHESIVE
HIGHBOND EB406 is a high-performance, two-component, 100% solids, moisture-insensitive epoxy bonding agent, and adhesive. It’s specifically designed for multipurpose applications, offering high strength and durability. This high-modulus, medium-viscosity resin is ideal for bonding new, plastic concrete to existing concrete slabs and steel, enhancing water and abrasion resistance while increasing overall durability.
HIGHBOND EB406 is perfect for use in internal and external renderings, flooring screeds, and patch repairs. It’s suitable for both internal and external applications where improvements in the physical properties of building structures are needed.
Features
- Provides exceptional adhesion
- Ensures bonding of floor Easy to use mixing ratio
- Not regulated and non-corrosive
- Waterproof barrier and bonding agent
- Moisture insensitive for damp applications
- Good abrasion resistance and proven performance
- Good resistance to many chemicals, frost, salt, and mineral oil.
- Excellent adhesion to steel and concrete.
- Adheres well to brick, glass, asphalt, wood, expanded polystyrene, etc
- Low VOC and Green building comply.
Application
- Bonding concrete, masonry, steel, fiberglass, and wood
- Anchoring bolts, dowels, or pins
- Sealing cracks and setting ports before injection
- General adhesive for concrete and masonry
- Corrosion protection for steel
- Priming and waterproofing steel reinforcement before patching or concrete pouring
- Promoting adhesion of concrete, bedding mortars, or toppings to non-cementitious substrates like tile, plywood, or steel
Instructions for Use:
Bonding Fresh Concrete to Hardened Concrete:
Apply EB406 by brush, roller, squeegee, or spray to the prepared, existing concrete substrate. Place fresh concrete onto the applied EB406 while it is still tacky. Open time typically ranges from 2 to 4 hours at 25°C to 35°C. At warmer temperatures, open time reduces. If EB406 loses tackiness or exceeds open time, abrade the epoxy surface, clean it, re-apply EB406, and proceed.
Bonding Hardened Concrete to Hardened Concrete:
Apply EB406 evenly using a spatula, brush, or trowel to both surfaces. Ensure uniform coating before joining the surfaces. Hold or clamp firmly until the epoxy gels. A small amount of adhesive should ideally exude from the joint. Surfaces must be mated while the adhesive is still tacky.
Anchoring Bolts, Dowels, and Pins:
EB406 can be used neat or as a mortar for grouting vertically aligned anchors into a horizontal substrate. Ensure the anchor hole is free of debris before grouting.
Patching and Repairs:
Apply EB406 as a primer coat to the prepared concrete surface. Use a trowel or spatula to apply the prepared EB406 mortar mix in lifts before the primer becomes tack-free.
Setting Ports & Sealing Cracks:
Place a small amount of mixed EB406 on the back of the port and carefully center it over the crack, ensuring not fill the injection port hole. Allow the mortar to harden sufficiently before injecting.
Pick-Proof Sealant:
Apply a bead of EB406 to the joints and areas being sealed. Finish by striking off the epoxy with a rounded spatula or similar tool.
Packing
5 Litre (Two Pack )